InMode Morpheus8 - Troubleshooting Morpheus8 System Issues; Faults and Troubleshooting Guide

Morpheus8 Body Applicator Operator
Manual
Section 7: Troubleshooting
26 of 34
Section 7: Troubleshooting
The InMode System with Morpheus8 Body Handpiece provides monitoring of all critical
parameters to ensure safety of patient and user. If any of the following faults are detected
system automatically goes to STAND BY mode.
7.1 Description of Faults with All Handpiece
Problem
Description and Checks
System did not turn on
▪ Check power cord connection.
▪ Check that On/Off switch on front panel is on.
▪ Check fuses on back panel of the System.
▪ Call Technical Service if problem persists.
System shuts down by
itself
▪ Check power cord connection.
▪ Check fuses on back panel of the System.
▪ Call Technical Service if problem persists.
Checksum
▪ The software was not loaded properly from
software plug.
▪ Check the plug connection and reboot the System.
▪ Call Technical Service if the problem persists.
Fault H8002 - Handpiece is
not connected
▪ Check the connection of the Handpiece.
▪ Replace the Handpiece.
▪ Call Technical Service if the problem persists.
Fault H8005, H800F, H8010
– System Memory Fault
Call Technical Service if the problem persists.
Fault H800E- System
Incompatible Software
Version
Call Technical Service if the problem persists.
Fault H800F- System
Memory Fault
Call Technical Service if the problem persists.
Faults H8003, H8006,
H8007 - RF Related Faults
Call Technical Service if the problem persists.