Inner Range Concept 2000 User Manual

C2000 User Manual
Page 22 of 26
ACCESS CONTROL
13.1 OPERATING DOOR-LOCKS
Concept 2000 Terminals may be installed to control electrically operated door locks. Your alarm Installer can advise
you on the full Access Control capabilities of the system.
The electric door lock is operated by pressing the OK key a second time, when the Concept 2000 Terminal is displayed
an Area name to turn On or Off.
The electric lock will only operate if:-
• The Area the lock provides access to is currently turned Off.
• The User is allowed to control that Area.
• The User is using the Terminal next to lock.
• The User is within the permitted Time Zone(s), (See “User Codes”)
If a User is defined as a “Lock only user” (See “User codes”), then the OK key does not have to be pushed a second
time.
When the electric lock operates, the display window will show the following message for 5 seconds:-
If the electric lock is allowed to operate at this time, the display window will show the following message for 5 seconds:-
Whether the electric lock operates or not, you must enter your secret code again if you wish to perform other panel
operations.
Provided for Download by www.bendigosecurity.com.au

Inner Range Concept 2000 Specifications

General

Brand	Inner Range
Model	Concept 2000
Category	Security System
Language	English