C2000 User Manual
Page 11 of 26
CHANGE CODES
All Users who are allowed to operate your Concept 2000 panel are issued numbers from000 to 016.
• Note: Some systems may allow up to 96 Users and others to 512.
Each User has their own name and their own secret code. One of the Users has to be given the responsibility of setting
up and making the required changes to User codes.
The User with this responsibility is User 000 and is referred to as the MASTER USER.
When User 000 presses the MENU key, one of the options available to him/her is:-
“2 = Change Codes”
If Users are to be altered, or more Users added, then User 000 selects this option.
When Change Codes is first entered, the display window shows:
Either enter the specific User number to alter, using the digit keys, or press the OK key to proceed with the displayed
User number.
• For the following options, pressing the OK key will advance to the next question
• Pressing the LEFT arrow will go back to the previous question.
• Pressing the UP or DOWN arrows will display the current question for other User numbers.
• For Yes/No questions, press the “9” key for “Yes” and any other digit key for “No”.
• Note: A “No” is displayed as a “Blank”.
After selecting a User number to inspect or alter, the first item to enter is the User’s name.
This option allows the User’s name to be inspected or altered. The digit keys and the LEFT & RIGHT arrows can be
used to alter the displayed name.
• Note: The example used is User 002.
To select a letter, press the appropriate digit key where the desired letter appears. Press this key repeatedly until the
correct letter is displayed. Press the RIGHT arrow to advance to the next letter or the LEFT arrow to go back to the
previous letter.
• Pressing the OFF key clears the display.
• Pressing the ON key clears the display to the right of the cursor.
• A “space” is located with “9” key.
• Miscellaneous punctuation is located with the “0” key.
To Next Page
Loading...
Need help?
General
