34
9 Trouble Shootings
If you encounter any problem during using the projector, please refer to the below methods to
solve the problem, if you still can not solve the problem, please contact the distributor.
9.1 Projector can not be powered on, no image
1 check the power connection, the power work normal or not
Connect one end of the power cable to the projector, the other end to the socket. Be sure that
the connection is correct, and the power indicator works. If the indicator does not light on, please
replace the power cable or the adaptor.
2 Over-heat protection
If the projector works long time, the heat will high, when it reaches a setting figure, the projector
will be power off.
3 Obstacle in front of the lens
Remove the obstacle.
4 If using the battery to start the projector, no battery
Charging the battery and then use it. About the charging time, please refer to content in manual.
9.2 Image blurring
1 Projector lens does not focus properly
Use the focus to adjust.
To Next Page
Loading...
