- 5 -
Safety Instructions
Power-on
◆
Before power-on, make sure that the equipment is installed properly with
reliable wiring and the motor can be restarted.
◆
Before power-on, make sure that the power supply meets equipment
requirements to prevent equipment damage or even a re.
◆
At power-on, unexpected operations may be triggered on the equipment.
Therefore, stay away from the equipment.
◆
After power-on, do not open the cabinet door and protective cover of the
equipment. Failure to comply will result in an electric shock.
◆
Do not touch any wiring terminals at power-on. Failure to comply will result in
an electric shock.
◆
Do not remove any part of the equipment at power-on. Failure to comply will
result in an electric shock.
Operation
◆
Do not touch any wiring terminals during operation. Failure to comply will
result in an electric shock.
◆
Do not remove any part of the equipment during operation. Failure to comply
will result in an electric shock.
◆
Do not touch the equipment shell, fan, or resistor for temperature detection.
Failure to comply will result in heat injuries.
◆
Signal detection must be performed by only professionals during operation.
Failure to comply will result in personal injuries or equipment damage.
◆
Prevent metal or other objects from falling into the device during operation.
Failure to comply may result in equipment damage.
◆
Do not start or stop the equipment using the contactor. Failure to comply may
result in equipment damage.
Maintenance
◆
Equipment installation, wiring, maintenance, inspection, or parts replacement
must be performed by only professionals.
◆
Do not maintain the equipment at power-on. Failure to comply will result in
an electric shock.
◆
Before maintenance, cut o all equipment power supplies and wait at least 10
minutes.
To Next Page
Loading...
