Inovance MD280 Series - Page 147

MD280/MD280N User Manual Parameter Description
- 147 -
brake time at startup as set, as shown in Fig.6-12.
DC brake current at startup: The DC brake quantity added shall be set
according to the percentage setting of the rated current of the inverter. The
higher the brake current is, more powerful the brake effect is.
DC brake time at startup: It refers to the continuous DC brake time. If it is
set to 0, the inverter will be started directly without undergoing DC brake.
Output Frequency Hz
Output Voltage ˄V˅
Effective Value
DC Brake Quantity at Startup
Running Command
DC Brake Current at Startup
Time
Time
Output Frequency Hz
Output Voltage ˄V˅
Effective Value
DC Brake Quantity at Startup
Running Command
DC Brake Current at Startup
Time
Time
Fig6-13 Schematic Diagram for Brake Current at Startup
Speed-up/speed-down
mode
Factory
default
value
0
0 Straight
speed-up/speed-down
1 S curve
speed-up/speed-down
mode A
F4-07
Setup range
2 S curve
speed-up/speed-down
mode B
It is used to select the frequency change mode during the inverter start and
stop process.
MD280 series inverter provides two types of speed-up/speed-down times,
0: Straight speed-up/speed-down
The output frequency increases or decreases along the straight line. It can
select speed-up/speed-down time via the multifunctional digital input
terminals
efesotomasyon.com