1. Product Information
- 11 -
1
Figure 1-4 Internal view of MD290T200G to MD290T450G and MD290T220P to MD290T500P
Logo
Warning
label
DC bus terminals
Cable clamp
Castor
Housing
Bottom hoist hole
Input terminals (R, S, T)
See sections 3.2.1.
Top hoist rings
Protective cover of
DC bus terminals
Nameplate
Handle
Label of main
circuit wiring
Fixing pin of
extension PG card
See section 8.4.3.
Fan box
For replacement of fan,
see section 9.3.
Control circuit
terminals
See sections 3.3.
Grounding terminal
See sections 3.2.2.
Live indicator
Do not remove/install the drive
when this indicator is lighting.
EMC and VDR screw
Refer to Power Grid System in
section 3.2.2 and requirement on
current leakage in section A.1.8.
Ground bar
It is used for grounding of the
PG card and control board.
Fixing pin of
extension card
See sections 8.4.1 and 8.4.2.
Operating panel
See section 4.2.
Cabling tray and fixing
pin of ground cable of
control board
This ground cable can only be
connected to the ground bar after
the system is grounded reliably.
Interface of remote
operating panel
See section 8.3.
Barcode
View the serial number and
model of the drive here.
Front cover
See section 2.5.
Read the user guide of the AC drive carefully before
installation or operation.
Do not remove the front cover while the power is on or
within10 minutes after the power is turned off.
Wait for a period of 10 minutes after the AC drive is powered
off before starting any repair, maintenance or wiring work .
i
10min
Output terminals
(U, V, W)
To Next Page
Loading...
