Appendix
- 323 -
12
Para. No. Para. Name Setting Range Default Property Page
F9-27 Frequency upon 2nd fault - - Ɣ -
F9-28 Current upon 2nd fault - - Ɣ -
F9-29 Bus voltage upon 2nd fault - - Ɣ -
F9-30 DI state upon 2nd fault - - Ɣ -
F9-31 DO state upon 2nd fault - - Ɣ -
F9-32 AC drive state upon 2nd fault - - Ɣ -
F9-33 Power-on time upon 2nd fault - - Ɣ -
F9-34 Running time upon 2nd fault - - Ɣ -
F9-37 Frequency upon 1st fault - - Ɣ -
F9-38 Current upon 1st fault - - Ɣ -
F9-39 Bus voltage upon 1st fault - - Ɣ -
F9-40 DI state upon 1st fault - - Ɣ -
F9-41 DO state upon 1st fault - - Ɣ -
F9-42 AC drive state upon 1st fault - - Ɣ -
F9-43 Power-on time upon 1st fault - - Ɣ -
F9-44 Running time upon 1st fault - - Ɣ -
F9-47 Fault protection action selection 1 00000 to 22222
Input phase loss (Err12):
Same as that of units position
Motor overload (Err11):
0: Coast to stop
1: Stop according to stop mode
2: Continue to run
Output phase loss (Err13):
Same as that of units position
Communication fault (Err16):
Same as that of units position
External fault (Err15):
Same as that of units position
00000
ƿ
1
5
6
F9-48 Fault protection action selection 2 00000 to 11111
EEPROM read-write fault (Err21):
0: Coast to stop
1: Stop according to stop mode
Encoder fault (Err20):
0: Coast to stop
1: Switch over to V/F control, stop
according to stop mode
2: Switch over to V/F control,
continue to run
Reserved
Accumulative running time
reached (Err26):
0: Coast to stop
1: Stop according to stop mode
2: Continue to run
Motor overheat (Err25):
0: Coast to stop
1: Stop according to stop mode
2: Continue to run
00000
ƿ
1
5
6
To Next Page
Loading...
