Mechanical Installation
‑28‑
Figure 1‑15 Installing the AC drive to the beam
7. After installation is done, remove the guide rail.
8. Remove the air filter paper board at the top of the AC drive. The air filter paper
board is used to prevent foreign objects such as screws from falling into the air filter
during installation of the AC drive into the cabinet.
Figure 1‑16 Removing the air filter paper board
1.2.4 Cover Removal and Installation
1.2.4.1 Removing the Cover
Before wiring the control circuit, such as operating jumpers or connecting PG cards or
expansion cards, remove the cover from the AC drive. When removing the cover, hold
the cover with your hands and carefully lift the lower part of the cover to prevent it
from falling off. Failure to comply will result in equipment damage or personal injury.
To Next Page
Loading...
