Electrical Installation
‑42‑
T10 to T12 models
Figure 2‑7 Layout of main circuit terminals for T10 to T12 models
Table 2–2 Descriptions of main circuit terminals
Terminal
Identification
Name
Function
R, S, T
Three‑phase power supply input
terminals
The terminals are used to
connect the three‑phase AC
power supply.
+, ‑
Positive and negative terminals
of the DC bus
Common DC busbar input;
connected to an external
braking unit.
U, V, W
AC drive output terminals The terminals are used to
onnect to a three‑phase motor.
Grounding terminal (PE) It is used for protective
grounding.
2.3 Descriptions of Control Circuit Terminals
"
Table 2–5
"
on page 46
shows the layout of control circuit terminals.
To Next Page
Loading...
