Inovance MD800 Series - Page 48

Commissioning and Trial Run
‑47‑
Parameter
No.
Communication
Address
Parameter Name Setting Range Default Unit Property
FA‑75 64075 Total power‑on time
(in seconds) upon 2nd
fault
‑ 0.0 s Modification
prohibited
FA‑80 64080 1st (5th latest) fault
code
‑ 0.0 ‑ Modification
prohibited
FA‑81 64081 1st fault subcode ‑ 0.0 ‑ Modification
prohibited
FA‑82 64082 Bus voltage upon 1st
fault
‑ 0.0 V Modification
prohibited
FA‑83 64083 Heatsink temperature
upon 1st fault
‑ 0 °C Modification
prohibited
FA‑84 64084 Ambient temperature
upon 1st fault
‑ 0 °C Modification
prohibited
FA‑86 64086 Grid voltage Usr upon
1st fault
‑ 0 V Modification
prohibited
FA‑87 64087 Grid voltage Ust upon
1st fault
‑ 0 V Modification
prohibited
FA‑88 64088 Grid voltage Utr upon
1st fault
‑ 0 V Modification
prohibited
FA‑89 64089 Three‑phase
unbalance factor
upon 1st fault
‑ 0.00 % Modification
prohibited
FA‑90 64090 DI state upon 1st fault ‑ 0 ‑ Modification
prohibited
FA‑91 64091 DO/RO state upon 1st
fault
‑ 0 ‑ Modification
prohibited
FA‑92 64092 Stop command sent
by power supply unit
upon 1st fault
1: Ready to run
2: Coast to stop
3: Stop according to preset
mode
0 ‑ Modification
prohibited
FA‑93 64093 Total power‑on time
(in hours) upon 1st
fault
‑ 0 h Modification
prohibited
FA‑94 64094 Total power‑on time
(in minutes) upon 1st
fault
‑ 0 min Modification
prohibited
FA‑95 64095 Total power‑on time
(in seconds) upon 1st
fault
‑ 0 s Modification
prohibited