Inovance Monarch NICE-L-C-4002 - Group F0: Basic parameters

6 Parameter Description
-
181
-
6.2 Operation Panel
The function codes adopt the three-level menu.
■
The function code group is Level-I menu;
■
The function code is Level-II menu;
■
The function code setting is Level-III menu.
1 Meaning of each column in the function code table
Function
Code
Name Setting Range Default Unit Property
Parameter
No.
Full
name of
parameter
󶍽
value range of
parameter
Factory
default of
parameter
Unit of
measurement
of parameter
Operation
property of
parameter
(That is, whether
to allow
operation and
conditions)
" ☆ "
󶍾
state.
󶙓
★
󶙓󶍾
󶙓  󶙓󶍾
󶍾
prevent mal-function.
2 Function code groups
On the operation panel, press
PRG
and then / , and you can view the
󶍾
F0 Basic parameters FA Keypad setting parameters
F1 Motor parameters Fb Door function parameters
F2 Vector control parameters FC Protection function parameters
F3 Running control parameters Fd Communication parameters
F4 Floor parameters FE Display setting parameters
F5 Terminal function parameters FF Factory parameters (reserved)
F6 Basic elevator parameters FP User parameters
F7 Test function parameters Fr
Leveling adjustment
parameters
F8
Enhanced function
parameters
E0 to E9 Fault record parameters
F9 Time parameters FJ Factory parameters (reserved)