Inovance Monarch NICE-L-C-4002 - Group F8: Enhanced function parameters

6 Parameter Description
-
226
-
Function
Code
Name Setting Range Default Unit Property
F7-06 Overload function
0: Disabled
1: Enabled
0 -
☆
F7-06 is used to set the overload function. The values are as follows:
■
0: Disabled (overload forbidden)
■
1: Enabled (overload allowed)
NOTE
◆
Note that overload is allowed (F7-06 = 1) only in the heavy-load test. Once
the test is complete, forbid overload running immediately.
Function
Code
Name Setting Range Default Unit Property
F7-07 Limit function
0: Enabled
1: Disabled
0 -
☆
F7-07 is used to forbid limit switches. The values are as follows:
■
0: No (Limit switch enabled)
■
1: Yes (Limit switch disabled)
NOTE
◆
󶍾
switch. Use the function with caution.
Function
Code
Name Setting Range Default Unit Property
F7-08
Time interval of random
running
0 to 1000 0 s
☆
F7-08 is used to set the time interval between two times of random running.
Function
Code
Name Setting Range Default Unit Property
F7-09 Braking force test result
󶍾
1: Pass
2: Fail
0 - 
F7-10
Countdown for braking force
detection period
0 to 1440 1440 min
★
F7-09 indicates braking force test results performed by the system.
■
0: It indicates that the system has not performed any braking force test.
■
1: It indicates that braking force test passes.
■
2: It indicates that braking force test fails and the system reports the fault E66. The
brake must be inspected after any fault and can be reset only after the braking force
test passes.
F7-10 is countdown for braking force detection period.
The initial value is 1440 minutes, i.e. 24 h. The test is automatically triggered if the
system has no call after 12 h so that the stop time exceeds the energy saving time.
When it is smaller than 10 minutes ahead of 24 h, the system clears car calls without