Insignia NS-59P680A12 - Connecting an Outdoor Antenna; Connecting Cable TV

10
NS-51P680A12/NS-59P680A12
www.insigniaproducts.com
Connecting an outdoor antenna
Connecting a coaxial antenna
To connect a coaxial antenna:
1 Turn off your TV and all connected equipment.
2 Connect the antenna cable to the ANT IN jack
on the back of your TV.
Connecting a twin-lead antenna
To connect a twin-lead antenna:
1 Turn off your TV and all connected equipment.
2 Place the wires from the twin leads under the
screws on a 300-75 Ω adapter (not included).
Use a screwdriver to tighten the screws.
3 Connect the adapter to the ANT IN jack on the
back of your TV.
Connecting separate VHF and UHF antennas
If you have separate VHF and UHF antennas, you
need to connect the antennas to a combiner (not
included).
To connect separate VHF and UHF antennas:
1 Turn off your TV and all connected equipment.
2 Connect both antenna leads to a combiner (not
included).
3 Connect the combiner to the ANT IN jack on the
back of your TV.
Connecting cable TV
Without a cable box
To connect cable TV without a cable box:
1 Turn off your TV and all connected equipment.
2 Connect the cable TV cable to the ANT IN jack
on the back of your TV.
With a cable TV box that unscrambles all channels
To connect a cable TV box that unscrambles all
channels:
1 Turn off your TV and all connected equipment.
2 Connect a coaxial cable to the ANT OUT jack on
the cable TV box. This jack may be labeled
ANT OUT, VHF OUT, or OUT.
3 Connect the other end of the cable to the
ANT IN jack on the back of your TV.
4 Connect another coaxial cable between the
ANT OUT jack on the cable TV box and the
cable TV wall jack.
ANT IN
ANT IN
UHF
VHF
Note
Because your TV is cable-ready, you do not need a
cable box to view unscrambled cable channels.
ANT IN
UHF
VHF
ANT IN
ANT OUT
ANT IN
ANT IN