24
NS-51P680A12/NS-59P680A12
www.insigniaproducts.com
• Equalizer—Sets the equalizer mode. You can
select:
• Mode—Selects the sound mode among
the predefined settings. You can select
Standard, Music, Movie, Clear Voice, or
Custom.
• Balance L/R—Adjusts the balance
between the right and left speaker.
• 100 Hz, 300 Hz, 1kHz, 3kHz, and
10 kHz—Adjusts the level of different
bandwidth frequencies.
• Reset—Resets the equalizer settings to
the default values.
• SRS TruSurround HD—If the sound is in 5.1
Surround Sound format, downmixes the
sound to produce Surround Sound quality
audio through your TV’s speakers.
• Preferred Language—Selects the language
for a digital TV program, if multiple tracks are
available.
• Multi-Track Sound—Selects the audio mode
for an analog TV program. You can select
Mono, Stereo, or SAP (separate audio
program), depending on available audio
formats for the program. If you are having
difficulty receiving stereo audio, select Mono.
• Auto Volume—Automatically adjusts the
volume when changing channels. You can
select On or Off.
• Speaker Select—Selects the speakers the TV
sound is played through. You can select:
• External Speaker—Turns the TV speakers
off and plays the sound through the
speakers of a connected amplifier. When
you select this option, the volume and
MUTE buttons on the TV and the TV
remote do not work. You need to adjust
the volume using the amplifier controls.
• TV Speaker—Plays the sound through the
TV speakers.
• Sound Reset—Resets some or all of the
sound settings to the default settings. You can
select:
• Reset All—Resets all the sound settings to
default settings. Press ENTER to reset
sound settings.
• Reset Sound Mode—Resets the current
sound
Mode settings to default settings.
For more information, see the Equalizer
option in this step.
• Cancel—Cancels any changes you have
made.
4 Press
S or T, W or Xto adjust the option, then
press ENTER to confirm.
5 Press RETURN to return to the previous menu or
EXIT to close the menu.
Changing channel settings
Automatically searching for channels
To automatically search for channels:
1 Press MENU. The on-screen menu opens.
2 Press
S or T to highlight Channel, then press
ENTER to access the Channel menu. Antenna is
highlighted.
3 Press ENTER to access the Antenna option,
press
S or T to highlight Air (antenna signal) or
Cable (cable TV signal), then press ENTER to
confirm. For more information, see “Resetting
the Plug & Play option” on page 39.
4 Press
S or T to highlight Auto Program, then
press ENTER to access the option.
Note
You can also press MTS one or more times to
select the language for a digital program.
Note
You can also press MTS one or more times to
select the analog audio mode.
Note
Unless otherwise noted, all tasks in this section are
based on using the remote control.
Mode : Standard
Contrast : 95
Brightness : 45
Sharpness : 50
Color : 50
Tint (G/R) : G50/R50
Picture
Sound
Channel
Setup
Input
Sound
Channel
Setup
Input
Antenna : Air
Auto Program
Clear Scrambled Channel
Channel List
Fine Tune
Signal Strength
To Next Page
Loading...
