15
www.insigniaproducts.com
Connecting a digital audio amplifier
To connect a digital audio amplifier:
• Connect a digital audio optical cable (not
included) between the DIGITAL AUDIO OUT
(OPTICAL) jack on the back of your TV and the
DIGITAL AUDIO IN (OPTICAL) jack on the
amplifier.
Turning on your TV for the
first time
The first time you turn on your TV, the Plug & Play
wizard opens. The Plug & Play wizard guides you
through setting up basic settings including the
menu language, TV signal source, the channel list,
and time.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See
page 7 for details.)
• Connected an antenna, cable TV, or satellite
TV. (See pages 10 through 11 for details.)
• Connected the power cord. (See page 9 for
details.)
2 Press (power). The Plug&Play Select Language
of the OSD menu opens.
3 Press ENTER to access the menu, then press
S or T to highlight a language. You can select
English, French, or Spanish.
4 Press ENTER. The Select Home Use when
installing this TV in your home screen appears.
Notes
• When you connect your TV to a digital audio
amplifier, decrease the volume level on your TV
and use the amplifier controls to adjust the
volume.
• 5.1-channel sound is possible when the TV is
connected to an external device supporting
5.1-channel sound.
• When the receiver (home theater) is turned on,
you can hear sound output from your TV’s
optical jack. When the TV is using a DTV signal,
your TV sends out 5.1-channel sound to the
home theater receiver.
• When the source is a digital component such as
a DVD player and the source is connected to an
HDMI jack on your TV, only 2-channel sound is
sent to the home theater receiver. If you want to
hear 5.1-channel sound, connect the digital
audio jack on the source directly to an amplifier
or home theater, not your TV.
Back of TV
Digital audio optical cable
Note
You can also access these settings from the on-screen
menu.
Press MENU on the remote control, press
S or T to
highlight SETUP, then press ENTER. Press
S or T to
select Plug&Play, press ENTER, then press
S or T to
select the setting you want to adjust.
Note
Store Demo mode is only intended for use in retail
environments.
If your TV is accidentally set to Store Demo mode,
reset the Plug & Play option. For more information,
see “Resetting the Plug & Play option” on page 39.
Plug & Play
Select Language of the OSD.
Language : English
Select ‘Home Use’ when installing this TV in your home.
Plug & Play
Home Use
Store Demo
To Next Page
Loading...
