8
NS-CF43SS7
www.insigniaproducts.com
Setting the thermostat
1 The first time you turn the refrigerator on, adjust the thermostat to “7”
and run for at least two hours before putting food in.
2 After it is fully cooled, test it and adjust towards “4” to make less cool,
to best suit your needs. The “4” setting should be appropriate for
home or office refrigerator use.
Notes
• The refrigerator should always be plugged into its own
individual electrical outlet which has a voltage rating that
matches the rating plate.
• Never unplug your refrigerator by pulling on the power
cord. Always grip the plug firmly and pull straight out from
the outlet.
Notes
• Turning the thermostat to the “0” position stops the cooling
cycle but does not shut off the power to the refrigerator.
• If the refrigerator is unplugged or loses power, you must
wait three to five minutes before restarting the it. If you
attempt to restart before this time delay, the refrigerator
will not start.
• Large amounts of food will lower the cooling efficiency of
the refrigerator.
• If you choose to change the thermostat setting, adjust it by
one increment at a time. Allow several hours for
temperature to stabilize between adjustments.
NS-CF43SS7_17-0447_MAN_V2_ENG.fm Page 8 Friday, June 2, 2017 11:14 AM
To Next Page
Loading...
Need help?
General
