22
www.insigniaproducts.com
STEP 12: Assembling the small drawers - 1
You n e ed
1 Use a Phillips screwdriver to attach the small drawer left sides (9) and the small drawer right sides (10) to the small
drawer backs (11) with four 3.8 x 35 mm screws (E) each. Make sure that the grooves on the back and side panels
face the inside of the drawer. Don’t overtighten.
2 Use a Phillips screwdriver to attach two small drawer face brackets (H), flat side out, to the insides of the left and
right drawer sides using two 3.5 x 12 mm screws (G) each. Don’t overtighten.
3 Use a Phillips screwdriver to attach the small drawer bottom braces (13) to the small drawer backs (11) with one 3.8
× 35 mm screw (E).
Phillips screwdriver
E 3.8 x 35 mm screw (10)
G 3.5 x 12 mm screw (8)
H Small drawer face bracket (4)
9 Small drawer left side (2)
10 Small drawer right side (2)
11 Small drawer back (2)
13 Small drawer bottom brace (2)
8 Top drawer face
7 Middle drawer face
V KD Bolt (short) (2)
G
1
1
H
E
1
0
9
1
3
To Next Page
Loading...
