24
www.insigniaproducts.com
STEP 13: Assembling the small drawers - 2
1 Slide the small drawer bottoms (12) into the groove in the bottoms of both small drawers. The front edge of the
drawer bottoms should protrude slightly from the drawer assembly.
2 Insert a small KD cam (W) into the hole in the small drawer bottom brace (13).
3 Use a Phillips screwdriver to attach the top drawer face (8) to the front of one of the small drawers using two M6 ×
12 mm bolts (F), then tighten the KD cam on the small drawer bottom brace.
Phillips screwdriver
M M4 x 25 mm bolt (4)
L Handle (2)
8 Top drawer face
7 Middle drawer face
12 Small drawer bottom (2)
W KD Cam (small) (2)
F M6 × 12 mm
bolts (4)
1
2
To Next Page
Loading...
