www.insigniaproducts.com
8
1.5 Cu. Ft. Over-the-Range Convection Microwave
Setting up your microwave oven
See the Installation Guide (included in your box) to install and set up your microwave.
You can also find the Installation Guide online at www.insigniaproducts.com
by searching for NS-OTRC15SS9. On your
microwave’s product page, select Support & Downloads, then next to Installation Guide, select the language you want.
Installing the turntable
1 Place the turntable ring in the round depression in the bottom of the microwave oven so that it turns freely.
2 Place the glass turntable (flat side up) on the turntable ring so that the hub engages the turntable shaft in the bottom
of the oven. The glass turntable should not turn freely when it is correctly installed.
Using your microwave
Microwave cooking
1 Press MICROWAVE, then use the number pad to enter the cooking time that you want.
2 Press POWER LEVEL, then enter the power level that you want (1-10).
3 Press START to begin heating.
OR
For two-stage cooking, repeat steps 1-2 to program the second stage, then press START. The buzzer rings between
stages and automatically move on to the second stage.
Convection cooking
With preheating convection
1 Press CONVECTION. The display shows “100F.”
2 Press the temperature button (0-9 on the number pad) to select the temperature that you want. Do not enter the cook
time yet.
3 Press START to start preheating.
4 Place your food in the microwave, then use the number pad to enter the cooking time that you want.
5 Press START to begin cooking.
Notes:
• Never place the glass tray upside down. The glass tray should never be restricted.
• Both the glass tray and turntable ring must always be used during cooking.
• Always place all food and containers of food on the glass tray for cooking.
• If the glass tray or turntable ring cracks or breaks, contact your nearest authorized service center.
Note: For example, to enter 3 minutes and 15 seconds, press 3, 1, and then 5.
Level10987654321
Power 100% 90% 80% 70% 60% 50% 40% 30% 20% 10%
Display PL10 PL9 PL8 PL7 PL6 PL5 PL4 PL3 PL2 PL1
Notes:
• Two-stage cooking lets you program two cook times and power levels at the same time.
• You can check the power level during cooking by pressing POWER LEVEL.
Note: You can check the temperature during cooking by pressing CONVECTION.
Note: There are ten convection temperatures: 100°F, 150°F, 250°F, 275°F, 300°F, 325°F, 350°F, 375°F, 400°F, and 425°F.
To Next Page
Loading...
Need help?
General
