Insignia NS-PDP50 - Advanced Connections; Connecting a DVI Device; Connecting a Digital Audio Device

07-287 NS-PDP50 EnglishOnly.fm Page ll Wednesday, July II, 2007 12:05 PM
i;]_i_/hih _IQ ©_'_©_:_"_..... /_/_;_<_,_,-__ -_ _ "_"_ D
1iiiii]1i!!
iNSiGNiA
;_ii!!i!iiiiiii
Connecting a DVI device Connecting a digital audio device
To connect a DVI device:
1 Connect an HDMI-to-DVI cable to the
HDMI IN I/DVI jack on the back of your TV,
then connect the other end of the cable to the
DVI out jack on the external device.
AUDIO N ! i;r@)
(RGBJDVI t
Warning
Do not look into the DIGITAL AUDIO OUT jack.
The jack uses a laser that could damage your
eyes.
To connect a digital audio device:
1 Connect a digital optical cable to the
DIGITAL AUDIO OUT jack on the back of
your TV, then connect the other end of the
cable to the digital audio in jack on the
device.
Connect the single-plug end of a two-to-one
audio cable to the AUDIO IN (RGB/DVI) jack
on the back of your plasma TV, then connect
the double-plug end of the cable to the right
audio (red) and left audio (white) jacks on the
external device.
3 Turn on your plasma TV and the device.
4 Press INPUT one or more times to select
HDMII/DVI.
Note
If the external device supports the Auto HDMI
function, the screen resolution is automatically set
to 1280 x 720p.
If the external device does not support the Auto
HDMI function, you need to set the screen
resolution to 1280 x 720p.
'\ )'
Turn off your plasma TV's speakers. For
more information, see "Turning the speakers
on or off" on page 19.