07-287 NS-PDP50 English Only.fm Page 9 Wednesday, July 1l, 2007 12:05 PM
i;]_i_/hih _IQ ©_'_©;:_"_ ..... /_/_;_,_,-__ -_ _ "_"_ D
Connecting an antenna or cable TV
Analog and digital TV signals on a single cable
To connect an antenna or cable TV:
1 Connect one end of a 75 ohm cable to the
ANTENNA/CABLE IN jack on the back of
your TV.
Cable TV _i!i!i i
io. l
Antenna
2 Connect the other end of the cable to the
antenna or cable TV jack.
Analog and digital TV signals on separate cables
To connect an antenna or cable TV:
!iiii/ii_ii!!
iNSiGNiA
;_ii!!i!iiiiiii
Connecting a standard AN device
To connect a standard A/V device:
1 Connect the video (yellow), right audio (red),
and left audio (white) plugs on a standard
A/V cable to the AVl (back) or AV2 (side)
jacks on your plasma TV.
i
oR
Using a signal ampfifier or two-way spfitter
You may need to install a signal amplifier or a
two-way splitter if:
• Reception is poor (use a signal amplifier).
• Signal from the antenna needs to be split
between two TVs (use a two-way splitter).
Sidejacks shown
m
!0
Signal amplifier or
two-way splitter
Connect the plugs on the other end of the
cable to the corresponding jacks on the
external device.
3 Turn on your plasma TV and the device.
4 Press INPUT one or more times to select
AVl or AV2.
Connecting an S-Video device
To connect an S-Video device:
Connect an S-Video cable to the S-VIDEO
jack on the back or side of your plasma TV,
then connect the other end of the cable to the
S-Video out jack on the external device.
S-VIDEO (R) AUDIO (L)
@®.===
S-VIDEO VIDEO LAUD]O_
To Next Page
Loading...
