07-287 NS-PDP50 EnglishOnly.fm Page 13 Wednesday, July II, 2007 12:05 PM
Iiiiiii_ii!!
iNSiGNiA
;_ii!!i!iiiiiii
Selecting the video input source Adjusting the volume
To select the video input source:
• Press TUNER or INPUT to select the video
source.
If you press TUNER, you can select digital or
analog TV.
If you press INPUT, you can select TV, AVl,
AV2, Component 1, Component 2,
RGB-PC, HDMII/DVl, or HDMI2.
Note
Your plasma TV automatically detects connected
devices. When you press INPUT, only the video
sources that have devices connected to them
appear.
Note
Your plasma TV remembers the last selected
video input source even if the power cord is
unplugged.
Labeling a video input source
You can label a video input source to make it
easier to recognize.
To label a video input source:
1 Press MENU, then press ,_ or T to select
SETUP. The SETUP menu opens.
To adjust the volume:
• Press VOL+ or VOL- to increase or
decrease the volume.
• To mute the sound, press MUTE. To restore
the sound, press MUTE, VOL+, or VOL-.
Creating the channel list
When you press CH+ or CH-, your plasma TV
goes to the next or previous channel in the
channel list.
You should set up the channel list when you first
set up your plasma TV. You should update the
channel list when your antenna or cable
connection changes.
You can create the channel list automatically
from the EZ Scan menu, or you can create the
channel list manually.
You can still select a channel that is not in the
channel list by pressing the number buttons for a
channel.
Note
If you have turned on the Lock System, you need
to enter the password before you can create the
channel list.
Creating the channel list from the EZ Scan menu
When you scan from the EZ Scan menu, your
plasma TV scans for available channels in your
area and stores them in the channel list. Your
plasma TV skips any channels that have a weak
signal or no signal.
To create the channel list with EZ Scan:
1 Press MENU, then press A or T to select
SETUP. The SETUP menu opens.
2
3
4
5
Press _, then press A or T to select Input
Label.
Press _, then press A or T to select the
input source you want to label. You can
select AVl, AV2, Component 1,
Component 2, RGB-PC, HDMII/DVl, or
HDMI2.
Press 4 or _- to select the label.
Press EXIT to return to TV viewing or press
MENU to return to the previous menu.
Changing channels
To change channels:
• Press CH+ or CH-to go to the next higher or
lower channel.
• Or, press the number buttons for the channel
you want.
• Or, to select a digital sub-channel, select the
main channel, press -, then press the
number button for the sub-channel.
2 Press _, then press A or T to select
EZ Scan. The EZ Scan menu opens.
3 Press ENTER to start scanning for channels.
Note
Make sure that you let your plasma TV scan for
both ANTENNA and CABLE channels.
To Next Page
Loading...
