14
www.insigniaproducts.com
Using the oven controls
Oven control, clock and timer features and settings
#ITEM FUNCTION
1 Bake pad Touch this pad to select the bake function.
Flashes while in edit mode–you can change the oven temperature
at this point. Glows when the oven is in bake mode.
2 Start Pad Must be touched to start any cooking or cleaning function.
3 Display Shows the time of day, oven temperature, whether the oven is in
the bake or broil mode and the times set for the timer or automatic
oven operations. The display will show PRE while preheating. When
the oven reaches the selected temperature, the oven control will
beep and the display will show the oven temperature.
If “F– and a number or letter” flash in the display and the oven
control signals, this indicates a function error code.
If your oven was set for a timed oven operation and a power outage
occurred, the clock and all programmed functions must be reset.
The time of day will flash in the display when there has been a
power outage. Reset the clock.
Touch the OFF pad. Allow the oven to cool for one hour. Put the
oven back into operation. If the function error code repeats,
disconnect the power to the range and call for service.
4 Timer Pad Touch this pad to select the timer feature. Then touch the + and –
pads to adjust the timer.
Flashes while in edit mode–you can change the set time at this
point. Glows when the timer has been activated. Flashes again
when the time has run out until the control is reset.
5 Clock Set Pad To set the clock, press this pad twice and then press the + and –
pads. The time of day will flash in the display when the oven is first
turned on.
To Next Page
Loading...
Need help?
General
