33
4-Burner Electric Range
www.insigniaproducts.com
Metal marks and scratches
1 Be careful not to slide pots and pans across your cooktop. It will leave metal
markings on the cooktop surface.
These marks are removable using the ceramic cooktop cleaner with the
cleaning pad for ceramic cooktops.
2 If pots with a thin overlay of aluminum or copper are allowed to boil dry, the
overlay may leave black discoloration on the cooktop.
This should be removed immediately before heating again or the
discoloration may be permanent.
Carefully check the bottom of pans for roughness that would
scratch the cooktop.
Cooktop seal
To clean the cooktop seal around the edges of the glass, lay a wet cloth on it for
a few minutes, then wipe clean with nonabrasive cleaners.
Glass surface – potential for permanent damage.
Damage from sugary spills and melted plastic
1 Turn off all surface units. Remove hot pans.
2 Wearing an oven mitt:
• Use a single-edge razor blade scraper to move the spill to a cool area on
the cooktop.
• Remove the spill with paper towels.
3 Any remaining spillover should be left until the surface of the cooktop has
cooled.
4 Don't use the surface units again until all of the residue has been completely
removed.
Note: If pitting or indentation in the glass surface has already occurred, the cooktop
glass will have to be replaced. In this case, service will be necessary.
To Next Page
Loading...
Need help?
General
