19
2.1 Channel Soundbar System
www.insigniaproducts.com
Positioning the subwoofer
For the best sound results from your subwoofer, it should be placed
against a wall or in a corner of the room. The location within the room is
less important, because bass tones are omni directional.
Mounting your soundbar on a wall (optional)
You will need (not included with your soundbar):
1 Select a location close to your TV and directly in front of the
viewing/listening position. For best sound quality, choose a location
where sound waves are not blocked by furniture or other obstacles.
2 If you are mounting your soundbar to drywall, use the stud finder to
find the studs and mark the locations.
3 Drill two 15/64” holes into the wall 25.6 inches (650 mm) apart and
level.
4 If you are mounting on drywall without studs or on concrete, install
wall anchors (included) into the holes you drilled, using the
instructions that came with your anchors.
5 Secure two screws (included) to the wall or wall anchors (if required).
The screws must protrude from the wall by about 5/32" (4 mm). Use a
9/16” (3.6 mm) self-tapping wood screw (or similar), 1-1/8" (28.5 mm)
in length. The screw head must be approximately 9/32" (7 mm).
Notes:
• Make all connections to your soundbar before mounting the soundbar on a
wall.
• If you mount your soundbar on a wall, you will not be able to use a USB
thumbdrive as a sound source.
Level
Stud finder
(optional for wood
stud installation)
Drill and
drill bit
Hammer
Screwdriver
Tape measure
Tape
Screws (2) - 9/16” (3.6 mm) self-tapping, at
least 1 1/8” (28.5 mm) long
Wall anchors (2)
To Next Page
Loading...
