16
NS-SBAR21F20
www.insigniaproducts.com
Reconnecting to a paired device
When your soundbar is not paired to a device, the LED indicator blinks.
Connecting to a different device
1 On your Bluetooth device you are currently connected to, turn off the
Bluetooth function or unpair the soundbar in your Bluetooth device
list. The soundbar can now be connected to another Bluetooth
device.
2 Follow the section Positioning the soundbar on page 18 to connect a
new device.
Receiving a phone call while playing music
• When you receive a call while playing music through your phone, the
music stops automatically.
• When you hang up, depending on the setting of your phone, the
current track may resume playback.
Connecting the AC power
After you have connected your soundbar to an audio source, you need to
connect it to an AC power outlet.
1 Connect the AC power cord to the AC IN jack on the back of the
soundbar.
Your soundbar loses the Bluetooth
connection if you…
To reconnect...
Turn it off. Turn on your soundbar. Your soundbar
searches for the last connected Bluetooth
device and reconnects.
Move the Bluetooth device out of range. Move your Bluetooth device within 30 ft.
(10 m) of your soundbar.
Turn off your Bluetooth device. Turn on your Bluetooth device, then make
sure that Bluetooth is on.
Turn off Bluetooth on your Bluetooth
device.
Turn on Bluetooth on your Bluetooth
device.
Connect your Bluetooth device to
another Bluetooth device.
Disconnect your Bluetooth device from the
other Bluetooth device, then set your
device to pairing mode. Select
“NS-SBAR21F20” on your Bluetooth device.
Note: If a device does not automatically reconnect, you may need to reselect
“NS-SBAR21F20” on your Bluetooth device.
CAUTION: Make sure that the electrical outlet matches the input requirements
of 100-240 V, 50/60 Hz before connecting.
To Next Page
Loading...
Need help?
General
