Remove: Place one finger on the flat top of float valve. Turn lid over. Detach silicone cap from bottom
side of float valve. Remove float valve from top of lid. Do not discard float valve or silicone cap.
The float valve and silicone cap must be installed before use to seal in pressurized steam. Clean after
each use.
Install: Drop float valve into float valve hole on top of lid. Place one finger on the flat top of the float
valve. Turn lid over. Attach silicone cap to the bottom of the float valve.
While float valve is up, the contents of the cooker are pressurized. Do not attempt to remove lid. Refer
to the “Venting Methods” section in this Guide for information on releasing pressure.
Remove & Install Anti-Block Shield
Remove: Grip lid and press firmly against side of anti-block shield (pressing towards side of lid and
up) until it pops off the prongs underneath.
Anti-block shield must be installed before use and cleaned frequently. installed before use and cleaned
after each use.
Install: Place anti-block shield over prongs and press down until it snaps into position.
Anti-block shield prevents food particles from coming up through the steam release pipe, assisting
with pressure regulation.
To Next Page
Loading...
Need help?
General
