instantpot.com | 39
Care, cleaning and storage
Steam release valve
Remove the steam release valve
Pull the steam release valve up and off the
steam release pipe.
The steam release valve must be installed
before using the cooker.
Install the steam release valve
Place the steam release valve on the steam
release pipe and press down rmly.
The steam release valve sits loosely on
the steam release pipe when installed
properly but should remain in place
when the lid is turned over.
Anti-block shield
Remove the anti-block shield
Grip the lid like a steering wheel and use
your thumbs to press rmly against the
side of the anti-block shield (pressing
towards the side of the lid and up) until
it pops off the prongs underneath.
Install the anti-block shield
Place the anti-block shield over the prongs
and press down until it snaps into position.
Do not attempt to operate the pressure
cooker without the anti-block shield
installed.
Illustrations in this document are for reference only and may differ from the actual product.
Always refer to the actual product.
To Next Page
Loading...
Need help?
General
