Need help?Do you have a question about the Instron 3400 Series and is the answer not in the manual?
General| Brand | Instron |
|---|---|
| Model | 3400 Series |
| Category | Test Equipment |
| Language | English |
Details specific hazards and necessary precautions for safe operation of the testing system.
Describes the components and terminology of the testing system, including labeled diagrams.
Explains the meaning of safety and information labels used on the testing system.
Declares the system's conformity with relevant EU regulations and directives.
Information on how to obtain documentation, online help, and contact support services.
Details the range of documentation available for Instron products.
Discusses inherent risks in using testing equipment and recommends risk assessment.
Addresses crush hazard from rapid crosshead movement and provides safety recommendations.
Highlights pinch hazard and offers recommendations for safe grip operation.
Covers hazard from flying debris and necessary safety precautions.
Explains the Bluehill® Operator Protection feature for limiting speeds and pressures.
Procedure for leveling the testing system's load frame for stability and accuracy.
Verifies voltage and plug compatibility with the facility's power supply.
Details the various components of the testing system and their connections.
Describes the frame connections for the single column load frame.
Explains the functions of the power input connector, including ON/OFF switch and voltage setting.
Details the operation and safety implications of the emergency stop button.
Describes the controls and indicators on the testing system's frame control panel.
Outlines the software controls for setting parameters and collecting data.
Explains the software feature to limit crosshead speed and grip pressure during setup.
Details the recommended pneumatic grips and their integration with Operator Protection.
Guidelines for choosing the appropriate load cell based on expected test loads.
Step-by-step instructions for installing load cells, including specific models.
Guidance on selecting grips and fixtures based on specimen properties.
Procedure for installing grips onto the load cell and base adapter.
Procedure to eliminate backlash and deflections in the load string.
Guidelines for testing a group of specimens, with scenarios for interlock and no interlock.
Procedure for testing when the system has no interlock accessory.
Procedure for testing when the system includes an interlock accessory.
Steps to create a new sample file in the software.
Procedures for automatic and manual calibration of force or strain transducers.
Sets the transducer value to zero, defining the starting point for displacement measurement.
Explains setting hardware limits for crosshead travel to prevent over-travel.
Procedure to enable and set maximum/minimum limits for transducers.
Balances transducer configurations by removing offsets and resetting the value to zero.
Methods to stop a test using hardware controls or software settings.
Steps for safely shutting down the testing system and its components.
Addresses common issues like limit trips and suggests solutions.
Guidelines for periodic inspection, cleaning, and lubrication of the test system.
Procedures that can be performed by the user for system maintenance.
Information on diagnosing and resolving issues with load cells.
Lists and describes ancillary parts included with the system.
To Next Page
