3. Programming the lock
In order for the lock to be programmed, it has to be opened. For this purpose, the
lock can be opened with any user code.
In the delivery state, the lock can only be opened with the factory master code
(0 = user no. + 1 2 3 4 5 6 = master code,
0 123456
).
The most important functions of the lock can be programmed with the keypad;
extended functions are programmed with the PC software CombiComm and the
event log is read out with the PC software.
Programming with the keypad
Program number Function
0
Reprogram the master code
1
Program/reprogram/delete user codes
2
Activate the 4-eyes principle
3
Set the opening delay / release time
4
Set automatic locking after 10 sec.
5
Reset lock
6
Block / release lock
7
Start programming via PC
8
Set date and time
9
Set IO functions / set blocking element
To Next Page
Loading...
