3.3. Programming user codes
Note:
• The programming can only be done when the lock is open.
• Do not use any personal data for your new code such as birthdays or other
information that could be guessed from knowledge about you.
• After you have entered the new code, open and close the electronic lock
several times with the new code while the door is open.
• The programming or deletion of user codes is saved in the event log. (For
reading out the event log, see the manual of the PC software CombiComm)
Programming or creating a new user code
*1*
Enter program number 1
1*
Enter the user number (e.g. user 1)
123456 *
1
Enter the master code
111111 *
Enter the new user code
111111 *
1
Enter the new user code
Reprogramming the user code
*1*
Enter program number 1
1*
Enter the user number (e.g. user 1)
111111 *
1
Enter the master code or old user code
132132 *
Enter the new user code
132132 *
1
Enter the new user code
Deleting a user code
*1*
Enter program number 1
1*
Enter the user number (e.g. user 1)
123456 *
1
Enter the master code
*
1
Delete
Note:
When the 4-eyes principle is activated, it is not possible to delete all users;
at least one user must be programmed.
To Next Page
Loading...
