25
It
De
Playing tracks stored on a USB storage device
You can connect a USB storage device to the USB port
on the front panel and play music files on it.
0 You can play high-res sources in formats such as
WAV, FLAC, or DSD files distributed over the Internet.
For information on supported devices and file formats,
see “Compatible devices/media/file formats” (> 44).
1. Press the NET button.
2. Use the direction ( / ) buttons to select “USB” on
the display and press the Enter button.
3. Connect a USB storage to the USB port.
When a USB storage is detected, “USB” appears on
the display. If “USB” indicator flashes, check whether
the USB storage device is plugged in properly.
0 Depending on the USB storage device, reading
data from it may take some time.
0 If the media you connect is not supported or cannot
be connected properly, the message “No storage”
will be displayed.
4. Press the Enter button.
The name of the track or folder appears.
5. Use the direction ( / ) buttons to select a track and
press the playback (1) button.
0 If you have selected a folder, when you press the
playback (1) button, play starts from the first track
in the folder. You can select tracks inside the folder
by pressing the Enter button.
0 Only the music files in the same level of the folder
are played. You can also set repeat playback mode
to Full and play all tracks stored on the USB storage
device.
0 The USB port of this unit conforms to the USB 1.1
standard. Depending on the content being played,
the transfer rate may not be sufficient, which can
cause interruptions.
DTM40.7_mst.book 25 ページ ２０１５年７月２４日 金曜日 午後１２時５８分
To Next Page
Loading...
Need help?
General
