4
Precautions
1. Recording Copyright—Unless it’s for personal use only,
recording copyrighted material is illegal without the permission
of the copyright holder.
2. AC Fuse—The AC fuse inside the unit is not user-serviceable.
If you cannot turn on the unit, contact the dealer from whom
you purchased this unit.
3. Care—Occasionally you should dust the unit all over with a
soft cloth. For stubborn stains, use a soft cloth dampened with
a weak solution of mild detergent and water. Dry the unit
immediately afterwards with a clean cloth. Don’t use abrasive
cloths, thinners, alcohol, or other chemical solvents, because
they may damage the finish or remove the panel lettering.
4. Power
WARNING
BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
AC outlet voltages vary from country to country. Make sure
that the voltage in your area meets the voltage requirements
printed on the unit’s rear panel (e.g., AC 230 V, 50 Hz or AC
120 V, 60 Hz).
The power cord plug is used to disconnect this unit from the
AC power source. Make sure that the plug is readily operable
(easily accessible) at all times.
For models with [POWER] button, or with both [POWER] and
[ON/STANDBY] buttons:
Pressing the [POWER] button to select OFF mode does not
fully disconnect from the mains. If you do not intend to use the
unit for an extended period, remove the power cord from the
AC outlet.
For models with [ON/STANDBY] button only:
Pressing the [ON/STANDBY] button to select Standby mode
does not fully disconnect from the mains. If you do not intend
to use the unit for an extended period, remove the power cord
from the AC outlet.
5. Preventing Hearing Loss
Caution
Excessive sound pressure from earphones and headphones
can cause hearing loss.
6. Batteries and Heat Exposure
Warning
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat as sunshine, fire or the like.
7. Never Touch this Unit with Wet Hands—Never handle this
unit or its power cord while your hands are wet or damp. If
water or any other liquid gets inside this unit, have it checked
by the dealer from whom you purchased this unit.
8. Handling Notes
0 If you need to transport this unit, use the original packaging
to pack it how it was when you originally bought it.
0 Do not leave rubber or plastic items on this unit for a long
time, because they may leave marks on the case.
0 This unit’s top and rear panels may get warm after
prolonged use. This is normal.
0 If you do not use this unit for a long time, it may not work
properly the next time you turn it on, so be sure to use it
occasionally.
For U.S. models
FEDERAL COMMUNICATIONS COMMISSION
DECLARATION OF CONFORMITY
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Product Name: Network Stereo Receiver
Model Number: DTM-40.7
Responsible Party Name: Onkyo U.S.A. Corporation
Address: 18 PARK WAY, UPPER SADDLE
RIVER, NEW JERSEY 07458,
USA
Phone: 1-800-229-1687
FCC Information for User
CAUTION:
The user changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to
operate the equipment.
NOTE:
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician
for help.
For Canadian Models
NOTE:
CAN ICES-3 B/NMB-3 B
For models having a power cord with a polarized plug:
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT, FULLY INSERT.
Modèle pour les Canadien
REMARQUE :
CAN ICES-3 B/NMB-3 B
Sur les modèles dont la fiche est polarisée :
ATTENTION :
POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA
LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE
CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU
FOND.
This device complies with Industry Canada licence-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may
cause undesired operation of the device.
This transmitter must not be co-located or operated in conjunction
with any other antenna or transmitter.
DTM40.7_mst.book 4 ページ ２０１５年７月２４日 金曜日 午後１２時５８分
To Next Page
Loading...
Need help?
General
