To Next PageTo Next PageWhat causes howling when volume is turned up on Integra Receiver?
If you are experiencing howling when the volume is turned up on your Integra Receiver, it could be because the turntable and speakers are too close together. Try moving them farther apart.
Why is the sound rough or scratchy on my Integra DTM-5.3 Receiver?
If the sound from your Integra Receiver is rough or scratchy and the high-frequency range is not clear, the stylus of your turntable pick-up may be worn. Replace it. Also, the turntable stylus tip might be dirty, so clean it. Additionally, the treble control may be set too high, so turn it down.
Amplifier Section| power output | 100 Watts per channel |
|---|---|
| dynamic power output at 2 ohms | 2 × 170 Watts |
| dynamic power output at 4 ohms | 2 × 135 Watts |
| dynamic power output at 8 ohms | 2 × 140 Watts |
| total harmonic distortion at rated power | 0.08% |
| IM distortion at rated power | 0.08% |
| damping factor | 60 at 8 ohms |
| phono input sensitivity and impedance | 2.5 mV, 50 kohms |
| line input sensitivity and impedance | 150 mV, 50 kohms |
| video input sensitivity and impedance | 1 Vp-p, 75 ohms |
| phono overload | 120 mV RMS at 1 kHz |
Tuner Section FM| tuning range | 87.5 to 108.0 MHz |
|---|---|
| usable sensitivity mono | 11.2 dBf, 1.0 µV |
| usable sensitivity stereo | 17.2 dBf, 2.0 µV |
| signal-to-noise ratio mono | 76 dB |
| signal-to-noise ratio stereo | 70 dB |
| total harmonic distortion mono | 0.15% |
| total harmonic distortion stereo | 0.25% |
Tuner Section AM| tuning range | 530 to 1, 710 kHz |
|---|---|
| usable sensitivity | 30 µV |
| image rejection ratio | 40 dB |
| signal-to-noise ratio | 40 dB |
| total harmonic distortion | 0.7% |
General| power supply | AC 120 V, 60 Hz |
|---|---|
| power consumption | 2.8 A |
| dimensions | 17-1/8" × 5-7/8" × 13-7/16" |
| weight | 19.8 lbs. |
