61
En
■ Operating on the AV receiver
■ Operating on the remote controller
To control Zone 2, you must press Zone2 on the remote
controller first.
Adjusting the Volume for Zone 2
■ Operating on the remote controller
■ Operating on the AV receiver
Muting Zone 2
■ Operating on the remote controller
Tip
• To unmute, press Zone2 followed by Muting again.
Adjusting the Tone and Balance of Zone 2
Note
• Only analog input sources are output from the
ZONE 2 PRE/LINE
OUT
L/R
jacks and
ZONE 2 L/R
terminals. Digital input sources
are not output. If no sound is heard when an input source is selected,
verify that the source is connected to an analog input.
• While Zone 2 is on, u functions will not work.
• You cannot select different AM or FM radio stations for your
main room and Zone 2. The same AM/FM radio station will be
heard in each room. Namely, if you have selected an FM station
for the main room, that station will also be output in Zone 2.
• When you have selected NET or USB as the input selector, the
last selector selected will be set for both Main room and Zone 2.
• Zone 2 can also be unmuted by adjusting the volume.
• When Zone 2 is activated and its input selector is selected, the
power consumption of standby mode slightly increases.
• When setting the AV receiver to standby mode while Zone 2 is
active, the Z2 indicator is dimly lit.
• The Zone 2 level, balance, and tone functions have no effect on
the ZONE 2 PRE/LINE OUT jacks when the “Zone 2 Out”
setting is set to “Fixed” (➔ page 55).
Controlling Zone 2 Components
1
To turn on Zone 2 and select an input source, press
Zone 2 followed by an input selector button within
8 seconds.
Zone 2 turns on, the Z2 indicator lights on the
display.
To select AM or FM, press the Tuner input selector
button repeatedly.
To select the same source as the main room’s, press
Zone 2 repeatedly until “Z2 Selector: Source”
appears on the display.
To turn off Zone 2, press Off.
The zone is turned off.
1
Press Zone2 and then press 8Receiver.
Zone 2 turns on, the Z2 indicator lights on the
display.
2
To select an input source for Zone 2, press Zone2,
followed by an input selector button.
To select AM or FM, press the Tuner input selector
repeatedly.
Note
• You cannot select different AM or FM radio stations for
your main room and Zone 2. The same AM/FM radio
station will be heard in each room.
3
To turn off Zone 2, press Zone2 followed by
8Receiver.
Input selector buttons
Zone 2
Off
Zone 2 Level q/w
Tone
+, –
Input selector buttons
8Receiver
Zone2
Muting
VOL q/w
1
Press Zone2.
2
Use VOL q/w to adjust the volume.
1
Use Zone 2 Level q/w.
1
Press Zone2 followed by Muting.
1
On the AV receiver, press Zone 2.
2
Press the AV receiver’s Tone repeatedly to select
“Bass”, “Treble” or “Balance”.
3
Use + and – to adjust the Bass, Treble or Balance.
• You can boost or cut the Bass or Treble from –10dB
to +10dB in 2 dB steps.
• You can adjust the balance from 0 in the center to
+10dB to the right or +10dB to the left in 2 dB steps.
To Next Page
Loading...
Need help?
General
