Integra DTR-4.5 - Setting TAPE;MD;CDR Input Display; Configuring Input Display for RI Functionality

43
First Time Setup —Continued
If you connect an -compatible Integra MiniDisc
recorder or CD recorder to the TAPE IN/OUT jacks, for
to work properly, you must change this setting.
This setting can only be changed on the AV receiver.
Changing the TAPE/MD/CDR Display
1
Press the [TAPE] input selector
button so that “TAPE” appears
on the display.
2
Press and hold down the [TAPE]
input selector button (about 3
seconds) to set the display.
Repeat this step to select TAPE, MD, or
CDR.
Standby
Zone 2
1, 2
DTR-4.5En.book Page 43 Tuesday, August 10, 2004 9:39 AM