Integra DTR-4.5 User Manual

47
Basic Operation —Continued
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets
for quick selection.
Listening to the Radio
Tuning into Radio Stations
■ Auto Tuning Mode
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator appears on the display, as shown.
■ Manual Tuning Mode
The AV receiver changes FM frequency in 0.2 MHz
steps, 10 kHz steps for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Using the Tuner
1
Use the [TUNER] input selector
button to select either AM or FM.
In this example, FM has been selected.
1
Press the [Tuning Mode] button
so that the AUTO indicator
appears on the display.
2
Press the Tuning Up or Down [ ]/
[] button.
Searching stops when a station is
found.
Band Frequency
Standby
Zone 2
21
AUTOTUNED
FM STEREO
1
Press the [Tuning Mode] button
so that the AUTO indicator disap-
pears from the display.
2
Press and hold the Tuning Up or
Down [ ]/[ ] button.
The frequency stops changing when
you release the button.
Press the buttons repeatedly to change
the frequency one step at a time.
DTR-4.5En.book Page 47 Tuesday, August 10, 2004 9:39 AM

Integra DTR-4.5 Specifications

General

Brand	Integra
Model	DTR-4.5
Category	Receiver
Language	English