Integra DTR-5.1 User Manual

33
Using the remote controller
Note:
Make sure that you point the transmission part on the
remote controller toward the sensor area on the MD
recorder.
1. Press the MODE MD/AUX button.
2. Press the desired MD operation button.
Turning the power on and off to the MD recorder
ON/STNBY : Turning on or standby the power to
the MD recorder
MD operation buttons
: Track Down
: Track Up
: Playback
: Stop
: Fast reverse
: Fast forward
: Record
: Pause
EJECT : Eject
1~9, +10 : Numeric keys
ENT : Confirm
You may also use the following buttons:
VOL q/u : Adjusting the volume level of the
DTR-5.1
MUTING : Muting the sound from the DTR-5.1
Note:
First connect an Integra/Onkyo tape deck using the
connection. (See page 9.)
1. Press the MODE AUDIO/TAPE button.
2. Press the desired tape deck operation button.
TAPE operation buttons
: Playback
: Stop
: Fast rewind
: Fast forward
: Recording/pause
: Reverse play
You may also use the following buttons:
VOL q/u : Adjusting the volume level of the
DTR-5.1
MUTING : Muting the sound from the DTR-5.1
No preset codes are programmed into the MODE SAT,
CABLE, VCR, and TV buttons. You can use these buttons
to program remote controller signals of other devices.
(See page 34.)
You may use the following buttons:
VOL q/u : Adjusting the volume level of the
DTR-5.1
MUTING : Muting the sound from the DTR-5.1
Controlling an Integra/Onkyo MD recorder
Controlling an Integra/Onkyo tape deck
MODE SAT, CABLE, VCR, and TV buttons
REC
REC
1. MODE MD
MD
operation
buttons
Numeric keys,
ENT button
HOME THEATER CONTROLLER
RC-424M
1. MODE
AUDIO/TAPE
TAPE
operation
buttons
MODE SAT,
CABLE, VCR,
TV

Integra DTR-5.1 Specifications

General

Brand	Integra
Model	DTR-5.1
Category	Receiver
Language	English