39
Using a Macro function
This procedure will erase all remote controller codes for
the other devices and all macro operations that have
been programmed in the RC-424M (see pages 34, 36
and 37).
1. Open the battery cover and remove the batteries.
2. While pressing and holding down the ON button and
the STNBY button, insert the batteries in the correct
direction.
After inserting the batteries, release the buttons. The
SEND/LEARN indicator flashes slowly.
3. Press the ENT button.
The SEND/LEARN indicator lights up for about ten sec-
onds, then turns off. All programmed codes are
erased and the button memories return to the fac-
tory presets.
Note:
• Proceed to Step 3 immediately after Step 2. Other-
wise, the batteries will be consumed quickly.
• If you press any button other than the ENT button in
Step 3, no codes will be erased. In this case, repeat
the steps from the beginning.
Erasing all codes and operations programmed
in the buttons
1
2
3
2
3
HOME THEATER CONTROLLER
RC-424M
To Next Page
Loading...
Need help?
General
