Why is there no sound from Integra Receiver surround back speakers?
Q
qescobarAug 26, 2025
If there is no sound from the surround back speakers on your Integra Receiver, check the Surr Back Out setting. If one surround back speaker is connected, select “1 ch,” and if two surround back speakers are connected, select “2 ch”. If the Dolby D 6.1/DTS-ES setting is “Off,” there is no output to the surround back speakers. Change the setting to “Auto” or “On.” If the Dolby D THX Surround EX/DTS THX Surround EX setting is “Off,” there is no output to the surround back speakers. Change the setting to “Auto” or “On.”
R
raymond57Aug 25, 2025
Why is there no sound from Integra Receiver center speaker?
M
Michael MartinezAug 25, 2025
If there is no sound or very low volume from the center speaker of your Integra Receiver, check the connection between the amplifier and the speaker. Ensure the Listening mode is set to a mode other than Stereo or Direct. Verify the CENTER level is set to an appropriate volume. Confirm that CENTER SPEAKER is set to “Large” or “Small,” not “None.”
Integra DTR-7.1 Specifications
General
Audio Channels
7.1
Total Harmonic Distortion (THD)
0.08%
THX Certified
Yes
HDMI Outputs
1
Component Video Inputs
2
Component Video Outputs
1
Analog Audio Inputs
6
Headphone Jack
Yes
Tuner
AM/FM
Remote Control
Yes
Input Sensitivity
200 mV
Signal-to-Noise Ratio
100 dB
Input Connections
HDMI, Component, Digital Coaxial, Digital Optical, Analog Audio
Output Connections
HDMI, Component, Composite, Analog Audio, Subwoofer Pre-out
To Next Page
General
