70
En
Speaker Levels
You can adjust the volume of each speaker while listening
to an input source.
These temporary adjustments are cancelled when the AV
receiver is set to Standby. To save the setting you made
here, go to “Level Calibration” (➔ 56) before setting the
AV receiver to Standby.
■ Subwoofer 1
` –15.0dB to 0.0dB to +12.0dB in 1 dB steps.
■ Subwoofer 2
` –15.0dB to 0.0dB to +12.0dB in 1 dB steps.
■ Center
` –12.0dB to 0.0dB
to +12.0dB in 1 dB steps.
Note
• You cannot use this function while the AV receiver is muted.
• Speakers that are set to “No” or “None” in the
“Speaker Configuration” (➔ 54) cannot be adjusted.
• This function will not work when the Direct listening mode is
selected to play analog audio.
• This setting cannot be used while a pair of headphones is con-
nected.
Audyssey Settings
■ Dynamic EQ
See “Dynamic EQ” of “Source Setup” (➔ 60).
■ Dynamic Volume
See “Dynamic Volume
”
of “Source Setup” (➔ 61).
Dolby Volume
■ Dolby Volume
See “Dolby Volume” of “Audio Adjust” (➔ 58).
Late Night
With the Late Night function, you can reduce the dynamic
range of Dolby Digital material so that you can still hear
quiet parts even when listening at low volume lev-
els—ideal for watching movies late at night when you
don’t want to disturb anyone.
■ Late Night
For Dolby Digital and Dolby Digital Plus sources, the
options are:
` Off
:
Late Night function off.
` Low:
Small reduction in dynamic range.
` High:
Large reduction in dynamic range.
For Dolby TrueHD sources, the options are:
` Auto
:
The Late Night function is set to “On” or “Off”
automatically.
` Off:
Late Night function off.
` On:
Late Night function on.
Note
• The effect of the Late Night function depends on the material
that you are playing and the intention of the original sound
designer, and with some material there will be little or no effect
when you select the different options.
• The Late Night function can be used only when the input source
is Dolby Digital, Dolby Digital Plus, or Dolby TrueHD.
• The Late Night function is set to “Off” when the AV receiver is
set to Standby. For Dolby TrueHD sources, it will be set to
“Auto”.
Music Optimizer
The Music Optimizer function enhances the sound quality
of compressed music files. Use it with music files that use
“lossy” compression, such as MP3.
■ Music Optimizer
` Off
:
Music Optimizer off.
` On:
Music Optimizer on. The M.Opt indicator will light
(➔ 9).
Note
• The Music Optimizer function only works with PCM digital
audio input signals with a sampling rate below 48 kHz and ana-
log audio input signals. The Music Optimizer is disabled when
the Direct listening mode is selected.
• The setting is stored individually for each input selector.
To Next Page
Loading...
Need help?
General
