10 336521
Document
Number
Revision
Number
Description
Revision
Date
• Updated Section 4.2.10, Table 4-8 – 12V2
recommendation is now required
• Updated Section 4.3, Table 4-9 now shows T0, Timing
requirements T1 and T3 added for ALPM and note about
timing requirements in the year 2020
• Updated Section 4.3.4 to provide recommendation to
increase current on 5VSB for computers with ALPM
• Added Figure 4-6 in section 4.3.6 for more clarity
• Updated Section 4.4.2 5VSB fall time as recommendation
and loading conditions used in the test plan
• Re-wrote Section 4.5.8 for overall efficiency targets –
Added Section about Low Load Condition
• Re-wrote Section 4.5.9 to include Efficiency
recommendations for current Energy Regulations
• Updated Section 5.1
to include labeling instructions for
which DG timings are supported by the PSU
• Updated Section 5.2.2.3 Floppy Drive Connector to be
reference only
• Added Section 5.2.2.4 for PCIe* AIC connectors
• Updated Section 5.2.2.4.2, added Table 5-5 +12V power
8 pin connector pin out
• Updated Section 6.1 – Acoustic note about acoustic
targets can be customer specific
• Sections 11, 12, 13, 14, 15 and 16
Added form factor
revision summary to beginning of each form factor specific
section
• Added new Intel Test Plan Section
1.41 • Update Section 2.1 – Table 2-1 for 12V2 Processor sustain
and peak power updates
• Added Section 2.2 for HEDT processors support
• Updated Section 4.5.8 and added Table 4-14
• Update Section 4.3
– add note for T3
• Update Section 4.5.9 – for ENERGY STAR* Computers
Version 7.0
• Updated Chapters 11, 12, 13, 14, 15, and 16
CFX12V Specific Guidelines to version 1.61
LFX12V Specific Guidelines to version 1.41
ATX12V Specific Guidelines to version 2.51
SFX12V Specific Guidelines to version 3.41
TFX12V Specific Guidelines to version 2.51
Flex ATX Specific Guidelines to version 1.21
• Updated Test Plan Sections 16.2.1 and Table 16-2 - 12V2
load table - to match Table 2-1
• Updated Test Plan Sections 16.2.2 and Table 16-3 for new
95W load of 21A Continuous
• Updated Test Plan Sections 16.3.3 and Table 16-10 –
added 12W load level
• Updated Test Plan Section 16.6 to include mention of PSU
for new CPU TDP levels mentioned in Section 2.1
October
2017
To Next Page
Loading...
Need help?
General
