Technical Reference
73
2.10 Electrical Considerations
2.10.1 DC Loading
Table 34 lists the DC loading characteristics of the board. This data is based on a DC analysis of
all active components within the board that impact its power delivery subsystems. The analysis
does not include PCI add-in cards. Minimum values assume a light load placed on the board that is
similar to an environment with no applications running and no USB current draw. Maximum
values assume a load placed on the board that is similar to a heavy gaming environment with a
500 mA current draw per USB port. These calculations are not based on specific processor values
or memory configurations but are based on the minimum and maximum current draw possible from
the board’s power delivery subsystems to the processor, memory, and USB ports.
Use the datasheets for add-in cards, such as PCI, to determine the overall system power
requirements. The selection of a power supply at the system level is dependent on the system’s
usage model and not necessarily tied to a particular processor clock frequency.
Table 34. DC Loading Characteristics
DC Current at:
Mode DC Power +3.3 V +5 V +12 V -12 V +5 VSB
Minimum loading 300 W 5 A 11 A 19 A 0 A 0.34 A (S0)
1.25 A (S3)
Maximum loading 750 W 25 A 27 A 46 A 0.40 A 0.34 A (S0)
1.25 A (S3)
2.10.2 Add-in Board Considerations
The board is designed to provide 2 A (average) of +5 V current for each add-in board. The total
+5 V current draw for add-in boards for the desktop board is as follows: a fully loaded board (all
five expansion slots) must not exceed 10 A.
To Next Page
Loading...
Need help?
General
