Intel DQ35JO - Desktop Board Executive Series Motherboard User Manual

Intel Desktop Board DQ35JO Product Guide
44
7. Insert the bottom edge of the DIMM into the socket.
8. When the DIMM is inserted, push down on the top edge of the DIMM until the
retaining clips snap into place. Make sure the clips are firmly in place.
9. Replace the computer’s cover and reconnect the AC power cord.
Removing DIMMs
To remove a DIMM, follow these steps:
1. Observe the precautions in "Before You Begin" on page 31.
2. Turn off all peripheral devices connected to the computer.
Turn off the computer.
3. Remove the AC power cord from the computer.
4. Remove the computer’s cover.
5. Gently spread the retaining clips at each end of the DIMM socket. The DIMM pops
out of the socket.
6. Hold the DIMM by the edges, lift it away from the socket, and store it in an
anti-static package.
7. Reinstall and reconnect any parts you removed or disconnected to reach the DIMM
sockets.
8. Replace the computer’s cover and reconnect the AC power cord.

Intel DQ35JO - Desktop Board Executive Series Motherboard Specifications

General

Form Factor	Micro ATX
Socket Type	LGA 775
Memory Slots	4
Maximum Memory	8 GB
USB Ports	8 x USB 2.0
Supported Processors	Intel Core 2 Quad, Core 2 Duo, Pentium, Celeron
Video Outputs	VGA, DVI
LAN	10/100/1000 Mbps
BIOS	AMI BIOS
Chipset	Intel Q35 Express
Memory Type	DDR2
Memory Standard	DDR2 800/667 MHz
Expansion Slots	1 x PCI-E x16, 1 x PCI, 2 x PCI
Storage Interface	4 x SATA 3Gb/s, 1 x PATA
Audio	Realtek ALC888 High Definition Audio CODEC
Ethernet	Intel 82566 Gigabit Ethernet
Graphics	Intel Graphics Media Accelerator 3100