EasyManuals Logo

Intel ETHEREXPRESS PRO/100 User Manual

Intel ETHEREXPRESS PRO/100
178 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
Modem Reference 6-27
S4 Response Formatting Character
This register contains the ASCII value of the line feed character.
The factory default value is 10. You can set register S4 to any value
between 0 and 127. The modem uses a line feed character in
command mode when it responds to the computer.
S5 Command Line Editing Character
This register contains the ASCII value of the backspace character
and is applicable to asynchronous transmissions only. The factory
default value is 8. You can set register S5 to any value between 0
and 32, or to 127. The modem will not recognize the backspace
character if it is set to a value greater than ASCII 32.
S6 Wait Before Blind Dialing
This register determines how long the modem waits after going off-
hook before dialing the first digit. The wait must be at least 2
seconds. Register S6 can be set to any value between 2 and 65
seconds. The default is 2 seconds. The value of the W dial modifier
will override the value in register S6. This operation, however, may
be affected by some ATX options according to country restrictions.
Defaults and limits are country-specific.
S7 Connection Completion Time-Out
This register determines the number of seconds the originating
modem waits for a carrier signal from the answering modem before
hanging up. The timer is started when the modem finishes dialing
(originate), or goes off-hook (answer). In originate mode, the timer
is reset upon detection of an answer tone if allowed by country
restriction. The timer also specifies the wait for silence time with the
@ dial modifier (in seconds). S7 is not associated with the W dial
modifier. Register S7 can be set at from 1 to 255 seconds with a
default of 50 seconds. Defaults and limits are country-specific.

Table of Contents

Other manuals for Intel ETHEREXPRESS PRO/100

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Intel ETHEREXPRESS PRO/100 and is the answer not in the manual?

Intel ETHEREXPRESS PRO/100 Specifications

General IconGeneral
Device TypeNetwork adapter
Form FactorPlug-in card
Data Link ProtocolEthernet, Fast Ethernet
Data Transfer Rate100 Mbps
Compliant StandardsIEEE 802.3, IEEE 802.3u
Connector TypeRJ-45
Bus TypePCI
ChipsetIntel 82557
Full Duplex SupportYes
Wake-on-LAN SupportYes
Ports1 x RJ45
Data Rate10 Mbps / 100 Mbps
Operating Systems SupportedLinux, Windows

Related product manuals