Windows 3.x/MS-DOS Installation 4-5
Banyan VINES version 5.5
NDIS 2.0 Driver
Prior to installing the Banyan Vines client software, it is necessary to
determine the Interrupt Number for the PRO/100 PC Card. After you
have installed the Adapter, follow these steps to determine the Interrupt
Number:
1 Insert Intel Disk 2, Network Drivers Disk in the floppy drive.
2 At the DOS prompt, enter
M16BTEST.EXE
3 Press Enter.
4 When the Main Menu opens, run Test.
The IRQ number will be displayed when the Test is complete.
5 Write down the IRQ number to use when you proceed with the
installation.
For example, if the IRQ=6, write down the number 6.
Now continue with the Banyan Vines installation as follows:
1 In Windows 3.x run the Intel Installation Program from Intel Disk
1. Installation Disk, as described at the beginning of this chapter.
2 Choose Banyan VINES from the Select Network Operating System
screen.
3 Follow the prompts to complete the Intel segment of the installa-
tion. The Installation Program also creates a \VINES directory on
your hard disk.
4 Copy the files from the VINES Master disk into the VINES
directory.
5 Copy the PROTOCOL.INI file from the \NDIS directory on Intel
Disk 2. Network Drivers Disk into the VINES directory.
6 Change to the VINES directory.
7 Type PCCONFIG and select Network Card Settings, followed by
NDIS Ethernet.
8 Enter the IRQ value you wrote down in step 5 of the M16BTEST
procedure described above.
To Next Page
