Windows 3.x/MS-DOS Installation 4-49
Please specify a hexadecimal number for the IOADDRESS keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the IOADDRESS keyword in the PROTOCOL.INI file must be a
hexadecimal number.
Please specify a hexadecimal number for the MEMORY keyword
This message applies only to the NDIS 2.0 Driver. The value specified
under the MEMORY keyword in the PROTOCOL.INI file must be a
hexadecimal number.
Please specify either 8 or 16 for the WORDSIZE keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the WORDSIZE keyword in the NET.CFG or
PROTOCOL.INI file must be either 8 or 16.
Please specify a nonzero decimal number for the SOCKET keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the SOCKET keyword in the NET.CFG or
PROTOCOL.INI file must be a decimal number other than zero.
Please specify 0, 1, 2, or 3 for the MEMWAITSTATES keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the MEMWAITSTATES keyword in the NET.CFG or
PROTOCOL.INI file must be either 0, 1, 2, or 3.
Please specify 0, 1, 2, or 3 for the IOWAITSTATES keyword
This message applies to both the ODI and NDIS 2.0 drivers. The value
specified under the IOWAITSTATES keyword in the NET.CFG or
PROTOCOL.INI file must be either 0, 1, 2, or 3.
The memory test failed - Please select a different memory address
The memory test will write data into the memory, read them back, and
verify if they are the same. In this case, the memory written and read back
were found to be different.
To Next Page
Loading...
Need help?
General
