5
1. Technical specications
Hardware
4 xed antennas of 5 dBi
3
LAN
ports (100 Mbps each)
1
Internet
port (100 Mbps)
Realtek® RTL8197FN + RTL8812BRH Chipset
Flash
Memory 8 MB
RAM
memory 64 MB
Wireless parameters
Standards IEEE 802.11a/b/g/n/ac
Radio mode MU-MiMo
Mode of operation AP Router / Wireless Repeater / Wireless Client / Access Point
Frequency of operation
2.4 GHz
5 GHz
Bandwidth
2.4 GHz: 20, 40 MHz
5 GHz: 20, 40, 80 MHz
Transmission rate
2.4 GHz: up to 300 Mbps
5 GHz: up to 867 Mbps
Channels of operation
2.4 GHz: 1-13 (Brazil)
5 GHz: 36, 40, 44, 48, 149, 153, 157, 161
Maximum power (E.I.R.P.)
2.4 GHz: 63 mW (18 dBm)
5 GHz: 126 mW (21 dBm)
Receiver sensitivity at 2.4 GHz
802.11b 1 Mbps: -92 dBm
802.11g 54 Mbps: -74 dBm
802.11n 20 MHz MCS7: -71 dBm
802.11n 40 MHz MCS7: -70 dBm
Receiver sensitivity at 5 GHz
802.11a 6 Mbps: -86 dBm
802.11ac 80 MHz MCS9: -61 dBm
Security WPA-WPA2/PSK with TKIP and/or AES encryption
Description of LEDs
SYS
On: router initializing
Flashing: normal operation
Wi-Fi
On: Wi-Fi 2.4 and 5 GHz network(s) is/are active, but no data trafc
Off: Wi-Fi 2.4 and 5 GHz are disabled
Flashing: the 2.4 and 5 GHz network(s) is (are) active and there is data trafc
Flashing slowly: WPS is running and waiting for a device to connect
Internet
On: there is a device connected to the corresponding port, without data trafc
Off: no device connected to the corresponding port
Flashing: there is a device connected to the corresponding port, with data trafc
LAN 1/2/3
On: there is a device connected to the corresponding port, without data trafc
Off: no device connected to the corresponding port
Flashing: there is a device connected to the corresponding port, with data trafc
Power supply
Input 100-240 V to 50/60 Hz
Output 9 Vdc/1 A
Maximum power consumption 9 W
Attention: this equipment has no right to be protected against harmful interference and may not cause interference to duly autho-
rized systems.