35
Setting the LNB Local Frequency
It is possible to select a local frequency from ACU. It is not recommend-
ed for a novice satellite service user to use this mode.
Case1. Single band LNB is used.
1. Press YES to enter setup mode.
2. Press NEXT four times to enter set local
frequency mode.
3. Press YES to set local frequency.
4. Select the LNB Type* - SINGLE.
PREV - Shows previous LNB type.
SELECT - Set the displayed LNB type.
NEXT - Shows next LNB type.
Press ENTER to move to next screen.
SETUP MODE ?
SET SAT PAIR ?
SET LOCAL FREQ ?
LNB TYPE : SINGLE
YES
PREV
PREV
PREV
NO
NEXT
NEXT
NEXT
YES
YES
SELECT
X4
5. Input the local frequency of LNB.
+ increases the value. - decreases the value.
Change the underscored digit using the
+/-buttons.
Press INPUT to accept the value and move to
next digit.
Press BACK to move to previous digit.
Press ENTER to move to next screen.
6. Press YES to accept the data.
Press NO to cancel and return to main setup
mode.
LOCAL FREQ: #####MHz
SAVE ?
-
YES
+
NO
INPUT
To Next Page
Loading...
Need help?
General
